WildSUP User guide
How to hold a paddle?
Inflatable stand up paddle board parts
Assembly instructions / Inflation / Deflation
Inflate your board with the pump included with your board. This pump will have the hose and adapters to fit the valves on this board.
The Inflation Procedure:
1. Choose a smooth and clean surface to unfold your board.
2. Unscrew the valve cap.
3. Push button in and turn approximately 90 degrees so it is in the “OUT” position.
4. Insert the pump hose end piece and inflate until you reach the required pressure.
5. After inflation, tighten all the valve caps (clockwise). Only the valve(s) cap can ensure final
AIR TIGHTNESS.
6. To release air from the side tubes and bottom floor tube, remove the valve cap (1) and push button (2) in and turn approximately 90 degrees so it is in the “IN” position.
Valve Diagram
